11
2 4 4 1 2 M a i n S t . S u i t e 1 0 5 , C a r s o n , C A 9 0 7 4 5
5-If Cleaning LED flashes quickly and the unit stops making ice (If this
section can
l e
blem, lea e g ec i n
10 or check your
installation clearances and ambient temperature)
x
Empty the ice bin and water reservoir following instructions in Section 2.
x
Fill the water reservoir with clean potable water to MAX WATER FILL.
x
Plug the unit into power.
Add Water LED will flash quickly with 5 beeps if
the water reservoir is full.
x
Press and hold the Clean button for 3 seconds to start cleaning for
defrosting process. The Cleaning LED will illuminate (it takes 30 minutes
to complete and the Cleaning LED goes off).
x
Press the
Make Ice
button once to start making ice.
6-If all LEDs illuminate simultaneously and water is filled to MAX
WATER FILL
x
Drain water following instructions in Section 1.
x
Fill the water reservoir with clean potable water to MAX WATER FILL.
x
Plug the unit into power again. Add Water LED will flash quickly with 5
beeps if the water reservoir is full.
x
Disconnect the UR tube connector for 5 seconds to release air and
reconnect it again.
7-If the unit
d e n a
making ice but it has dispensed all ice
x
Press and hold the Dispense button for more than 30 seconds to restart
making ice.
8-If ice is jammed at the dispense point and the
ni can
dispense ice
x
Remove the jammed ice in the dispense point with a teaspoon.
x
Or
break the jammed ice
by pressing the Clean button while you hold
the Dispense button
.
x
Then press and hold the Dispense button to dispense ice.
