9
2 4 4 1 2 M a i n S t . S u i t e 1 0 5 , C a r s o n , C A 9 0 7 4 5
x
Add clean potable water to MAX WATER FILL following instructions above.
x
Plug the unit into power. Add Water LED will flash quickly with 5 beeps if
the water reservoir is full.
x
Press the Make Ice button once to start making ice, the Making Ice LED
illuminates
.
Filling the water reservoir when the Add Water LED illuminates
NOTE
Do not add water until Add Water LED illuminates.
Do not overfill the reservoir otherwise it may overflow when ice
melts completely.
x
Insert a funnel into the push-to open fill port.
x
Add clean potable water using the funnel until the Add Water LED
flashes
quickly with 5 beeps and then goes off.
x
Remove the funnel to close the fill port.
Or
x
Remove the reservoir door to add clean potable water to MAX WATER
FILL until you hear
5 beeps.
If the Cleaning LED flashes quickly and the unit stops making ice
x
Go to the section 5 of DISPENSER CARE
.
If the ice dispenser hasn t been interacted in the past 4 hours
x
The unit will enter energy saving mode
.
If the ice dispenser hasn t been interacted in the past 72 hours
x
The unit will enter idle mode
.
If you are away on holidays or vacations
x
Empty the ice bin and water reservoir
.
