12
Operation and Service KBL 6900 / MAX10
aquaCool
Off
ON
Facial tanner/
Shoulder tanner
The control of the shoulder tanner is coupled to the facial tanner.
The shoulder tanner is switched on whenever the facial tanner is
activated but its power cannot be turned down. As soon as the fa-
cial tanner is switched off, the shoulder tanner is turned off as well.
Important: Do not operate the shoulder tanner without lamp
unit.
Level II Once the tanning program has been started, the facial
tanners are automatically switched on at maximum
setting.
Level I To reduce the output to level I, use the field “–”.
Level 0 To switch off the facial tanners completely, touch the “–”
field again for at least 3 seconds.
By touching the “+” field you can switch the facial tanners on
again or you can increase their output.
When the system has been switched off, there will be a time lag
before you can switch it on again due to the necessary cooling
of the burners.
Here you can activate the aquaCool water-atomisation func-
tion (plus button, symbol flashes) or deactivate it (minus button,
symbol does not flash). Default setting at start: as defined on
service level I in the AAC/Aqua menu.
• If the aquaCool supply is running low, the message Aqua low
is shown on the display between the tanning sessions. When
the message appears for the first time, the aquaCool supply
will last approx. another 2.5 hours of operation with aquaCool.
• If the aquaCool supply is empty, the message Aqua 0% ap-
pears and the symbol is crossed out. If the system is to be
used without aquaCool, you can switch off the messages
and the symbol. For this purpose, set the submenu Aqua
to “OFF”. To reach this menu, proceed to the AAC menu on
service level II.
Water tank is
empty
