11
Operation and Service megaSun 4500
3. Maintenance of the unit
Preparatory works
Plastic parts
Note
Acrylic panes
„megaClean“
Chromed parts
Dismantling the
pane in canopy
Before opening the unit, switch off the fuses to disconnect it
from the mains supply!Never operate the tanning unit without
the bulkhead plates, acrylic panes or with the bed section
opened, for otherwise the tanner areas will become overheated.
This will destroy the
fi
lter panes!
The major plastic parts consist of solid high-grade ABS material.
The surfaces and the acrylic panes must not be cleaned with
concentrated disinfectants or solvents or other liquids that
contain alcohol!The manufacturer cannot be held liable for any
damage caused by chemically active agents such as unsuitable
cleaning agents.To clean the varnished or plastic surfaces, use a
damp soapy cloth.Make sure that there is no cleaning fl uid run-
ning inside the appliance. This has to be avoided at any rate!
Unsuitable cleaning or disinfecting agents may damage the
surface of the acrylic panes (base pane) and further materials,
particularly if there are drops of perspiration in addition to that.
The cleaning and disinfecting agent “megaClean“, to be purcha-
sed from KBL, has speci
fi
cally been developed for use on acry-
lic surfaces and is regarded as safe. It is diluted in water at a
ratio of 1:13.
Clean only with a damp (not wet) washleather and a plexiglass
cleaner (antistatic). The cleaning agent must be applied onto the
cleaning cloth and not directly onto the chromed parts.
The acrylic panes of both the canopy and the bed are held in
place by means of aluminium pro
fi
les. Two pan-head screws
secure the base pane.
3.1.
Cleaning and care
3.2. Dismantling the acrylic panes
