Assuming the tanning position
and starting / stopping the
tanning session
WARNING
UV radiation
UV radiation can cause skin and eye
injuries.
Observe the tanning instructions.
•
If in doubt, refrain from tanning.
•
ASSUMING THE TANNING POSITION
The door must be kept closed during the tanning
session in order to ensure the proper functioning of
the ventilation system. Persons with long hair need
to wear a hair net during the session.
Close the door and place yourself in the middle
1.
of the device. Make sure that you are positioned
at an equal distance between your body and the
surrounding sunlamps.
Put on the protective goggles.
2.
STARTING
To start the system during the warm-up time, press
the START button. After the set warm-up time
has elapsed, the tanning session will commence
automatically.
STOPPING
Keep the STOP button pressed for at least two
seconds. As an acknowledgement, you will hear a
sound signal, and the session-time display starts
fl ashing. The session is discontinued but the time
will continue to be counted. The tanning session can
be continued by pressing the START button if the
available session time has not elapsed yet.
After the time given by the timer has elapsed, the
session is terminated automatically, and the fan will
run on for three minutes.
Functions (KBL/4)
Use the plus button to switch on the
function or to set the next higher value.
Press the button as often as necessary to
set the maximum value (e.g. fan speed).
Use the minus button to switch off the
function or to set the next lower value.
Press the button as often as necessary to
set a lower value (e.g. volume).
Use the START button to switch on
the unit during the warm-up time.
If the tanning session has been interrupted by
pressing the STOP button, it can be continued by
pressing the START button, provided that the session
time available from the coin box/timer system has
not elapsed yet.
The tanning session can be terminated
prematurely by pressing the STOP
button for at least 2 seconds.
NUMERIC DISPLAY
While the tanning program is running,
the current session time is displayed
here. If you change the volume, the
set value between 0 ... 99% is
indicated here. If you change the fan speed, the value
between 20 and 99% is displayed.
TERMINATION OF THE TANNING SESSION
After the session time has elapsed, a program to shut
down the solarium is started:
A voice (for vocal guide systems) announces the
end of the tanning session and says goodbye to the
customer.
Sunlamps, tubes and ventilation are shut down in
steps.
The LEDs (for units equipped with activeColor) will
afterglow in the set colour for another 20 seconds.
O p e r a t i n g I n s t r u c t i o n s
|
megaSun 5600
18
