BODY FAN
The power of the body fan can be increased
or decreased in steps of 10 % by pressing
the “+” or “–” buttons.
After the fan has been switched on, it starts
at the power level set under ACS/A.START
in the service menu on level II.
Press “–” as often as necessary until the value 20%
is displayed to switch off the body fan. Then press
the button once again and keep it pressed for 0.5
seconds. After a time delay, the fan is turned off. You
can switch it on again at any time by pressing the “+”
button.
FIRST SUBMENU
/
CHANNEL SELECTION
This function allows you to select the audio
source, e.g. to change the channel or to
proceed to the next track (MP3).
The music can be selected by the studio
operator and then copied to the chip using
a computer.
The MP3 player is designed in such a way that
only the SD card containing the music needs to be
exchanged. All sunbeds equipped with MP3 players
supplied by KBL are delivered with the music of the
“megaSun & friends“ CD. Optionally, the music of
the MP3 player can be switched on during session
breaks.
Use the “+” or “–” buttons above or below the symbol
to switch over.
For channel selection, you can switch over to BCD
selection (see AUDIO menu on service level I).
Note: The music of the MP3 unit can only be
controlled by one audio source, i.e. either by the chip
of the MP3 player or by an external audio source.
AIR CONDITIONING
This function can only be found in this place
of the menu if aquaCool has been confi gured.
Otherwise, it is available on the next
operating level.
Use the “+” or “–” buttons to switch the
air-conditioning system on or off during the
tanning session. After the air-conditioning unit has
been switched off, it can only be switched on again
after 3 minutes. A small asterisk is displayed. If the
request for re-activation is made earlier, it is recorded
(big asterisk); after the 3 minutes have elapsed, it is
switched on automatically.
Exception: If the turning-off was effected by the coin-
controlled timer system, the unit can be switched on
again immediately.
FROM SOFTWARE VERSION 6.0 ON, OR, FOR
TANNING UNITS WITH EASYCARE, FROM
VERSION 3.0 ON
In this fi rst operating submenu, P means programme.
The user can choose from three audio sources during
the tanning session, provided that the sources are
available and have been activated in the service
menu I:
Wellness music,
•
Pop music
•
Music supplied by the studio control
•
P is displayed if at least two sources are available
and activated.
The new audio source is selected and briefl y
displayed by pressing the “+” or “–” button above/
below the “P”. Please refer to the service menu I for
more information.
The symbol “channel selection” means “next track”
for Wellness and Pop, and, as usual, “next channel of
the external audio source” for studio music.
Switching over is done by pressing the “+” or “–”
buttons above the channel-selection symbol.
O p e r a t i n g I n s t r u c t i o n s
|
megaSun 5600
20
