CHANNEL SELECTION
You can choose the next channel or go back
to the previous one by pressing the “+” or
“–” buttons above or below the symbol for
the audio source.
As far as the channel selection is concerned,
you can switch over to BCD or pulse
selection (see AUDIO menu on service level I).
VOLUME
The volume of the music can be changed by
pressing the “+” and “–” buttons. The current
value (in %) is displayed for a short period of
time.
The music can be switched off by pressing
the “–” button: fi rst, set the value to 20 %,
then press the “–” button once for a longer time.
AIR-CONDITIONING UNIT
Press the “+” or “–” buttons to switch the
air-conditioning unit on or off during the
tanning session. After the unit has been
switched off, it can only be turned on again
after 3 minutes. A small asterisk is displayed.
If the request to switch the air-conditioning
on again is made earlier, it is stored (big asterisk), and
the unit is automatically turned on after the 3 minutes
have elapsed. Exception: If the unit is switched off
via the coin-controlled timer system, it can be
restarted immediately.
FACIAL TANNER / SHOULDER TANNER
The control of the shoulder tanner is linked
with the facial tanner. The shoulder tanner is
switched on together with the facial tanner;
however, it cannot be reduced in power. If the
facial tanner is switched off, the shoulder
tanner is also deactivated.
IMPORTANT: Do not operate the shoulder tanner
without lamp unit
.
Level II: After the start of the tanning program, the facial
tanners automatically operate at maximum level.
Level I: The power is reduced to level I by pressing the
“–” button. This level is not available for megaSun 5600
Super, Super Power and Ultra Power models of UV
type 3.
Level 0: If you press the “–” button again for at least 3
seconds, the facial tanners are completely turned off.
Press the “+” button to switch the tanners on again, or
to increase their power.
After the tanners have been switched off, there is a time
delay before they can be switched on again because
the sunlamps must cool down fi rst.
BODY FAN
The power of the body fan can be increased
or decreased in steps of 10 % by pressing
the “+” or “–” buttons.
After the unit has been switched on, the fan
starts at the power level set under ACS/
A.START in the service menu on level II.
Press “–” as often as necessary to reach a value of
20% in order to deactivate the body fan. Then press
the button once again and keep it pressed for 0.5
seconds. After a time delay, the fan will stop running.
It can be switched on again at any time by pressing
the “+” button.
O p e r a t i n g I n s t r u c t i o n s
|
megaSun 5600
22
