Figure 43.1: Position of the P2 tubes in the canopy
MS 5800 / P2
T5-Röhren
Revision
A
Allgemeintoleranzen
nach DIN ISO 2768 -f
Norm
gepr.
megaSun
Datum
Name
---
Werkstoff
Verwendung
Gerät
---
grafische Darstellung
MS 5800 / P2
00
Gewicht
00
Menge
Maßstab
Benennung
Zn.- Nr.
1:20
gez. 16.10.2007
Müller
.
.
.
.
P2-Tubes
Figure 43.2: Centre retaining clamp of a P2 tube
WARNING!
Danger of destruction!
When installing/removing the P2 tubes,
pay utmost attention to the centre retaining
clamp.
Replacing the sunlamps of the
shoulder tanner
REPLACING THE SUNLAMPS
The sunlamps must be replaced after 600 hours of
operation. Let the unit cool down before replacing the
sunlamps. The tanning lamps must only be removed
and installed by trained and qualifi ed staff. The bed
pane must remain folded down during dismantling and
replacement.
Important:
Do not operate the shoulder tanner without
sunlamp unit.
Procedure
Fig.
1
Undo the screw of the outer covering
and lift off the outer covering upwards
and towards the front.
44.1
2
Undo the screws of the chromium-plated
covering and pull off the covering towards
the front.
44.2
3
Disconnect the refl
ector from the
electrical power supply by unplugging
the connector from the ignition device at
the place marked in the picture. Take out
the refl ector by pressing it downwards
vertically and by turning it to the left while
keeping it pressed. Make sure not to jam
the socket.
44.3
44.4
4
Press one side of the clamp down in
order to spread it apart, and then remove
the sunlamp by holding the socket at the
opposite side and by pulling in a diagonally
upward movement. The light bulb and its
base represent one single component.
44.5
O p e r a t i n g I n s t r u c t i o n s
|
megaSun 5600
43
