Procedure
Fig.
5
When installing the new sunlamp, do
not touch the glass with your bare
hands. This would cause stains that
burn in during operation. If you have
happened to touch the glass bulb,
though, clean it carefully using an
agent that contains alcohol.
Press the clamp down on one side,
take the new light bulb and insert
it so that it exactly fi ts the recess in
the lamp holder. Then press the lamp
base down on the opposite side until it
locks in place. Connect the plug to the
ignition device.
45.1
6
When installing the refl ector, the large
side of the stainless-steel ring must point
towards the centreline of the shoulder
tanner. Insert the refl ector as shown in
fi gure 45.2, push it down and turn it to
the right while keeping it pressed. Make
sure not to jam the socket.
45.2
7
Insert the chromium-plated covering
into the slots of the housing of the
shoulder tanner, press it on and fi x
it with screws. Place the refl ector
correctly under the chromium-plated
covering. Press on the refl ector slightly
in order to align it.
45.3
8
Attach the outer covering vertically
and fasten with screws.
Figure 44.1: Undoing the screw of the outer covering
Figure 44.2 Undoing the screws of the chromium-plated covering
Figure 44.3: Disconnecting the refl ectors from the power supply at
the respective ignition device
Figure 44.4: Unscrewing the refl ector
Figure 44.5: Spreading the clamp apart and removing the sunlamp
including its base
O p e r a t i n g I n s t r u c t i o n s
|
megaSun 5600
44
