Figure 45.1: Inserting the new sunlamp so that it fi ts precisely
sung herausnehmen
Figure 45.2: Inserting the refl ector
Figure 45.3: Refl ector correctly positioned under the chromium-
plated covering
Dismantling the tanning lamps
Tanning lamps must only be installed and removed
by trained and qualifi ed staff.
Procedure
Fig.
1
Remove the fi lter panes.
2
Push the light bulb slightly aside and
then pull it out.
45.4
45.5
3
Proceed in reverse order for
installation.
Never touch a new tanning lamp with your bare
hands. If necessary, clean the light bulb using an
agent containing alcohol.
Figure 45.4: Pushing the light bulb aside
Figure 45.5: Pull out the light bulb towards the front
INSTALLING THE TANNING LAMPS
Dirt and bad seating can result in damage to the light
bulbs and the sockets during operation. Make sure
that the contact surfaces on both the lamp holder and
the light bulb are clean when you insert the lamps.
Insert the tanning lamps straight into their holders.
After the installation, the small glass pin in the middle
of the light bulb must point towards the refl ector.
Flat lug
O p e r a t i n g I n s t r u c t i o n s
|
megaSun 5600
45
