M a n u a l e o p e r a t i v o
|
megaSun 6700 - 6800 - 6900
22
Standby mode / service mode
While the tanning device is in standby mode, you can
switch the decorative lighting of the tanning device
on and off and trigger an aquaCool spraying test (1
spraying cycle).
When the tanning device is in service mode, you can
make the presettings for operation in tanning mode,
and you can have values concerning the operation of
the tanning device displayed.
Layout of the interior control
panel numbers
The buttons of the interior control panel are allocated
double functions. In addition to the standard
operating elements, they stand for numbers that,
in standby mode, provide access to standby and
service functions. Simply enter the corresponding
sequence of numbers on the interior control panel.
1 2 3 4 5
0
9
8
7
6
Switching the decorative light-
ing on and off
5
0
5
NOTE
The connection times of the decorative lighting can
be set in the service menu individually for each day
of the week.
There are two independent connection periods (A
and B) available for each day of the week.
aquaCool spraying test
4
9
4
Invoking the service menu
CALL SERVICE MENU - START WINDOW
1 6 1
SERVICE MENU - START WINDOW
SERVICEMENU
Enter Servicemenu CODE
> CODE:
In standby mode, the service level is accessed by
entering the factory CODE 1 „00000“, the supplied
CODE 2 or individually defined CODES.
• No incoming signal from the coin-box system.
NOTE
Do not let too much time pass between the individual
keystrokes when entering a sequence of numbers!
Summary of Contents for megaSun 6900 alpha deluxe
Page 1: ...MANUALE OPERATIVO...
