Commissioning
Initial commissioning is carried out by the manu-
facturer or by trained and authorised specialist per-
sonnel. The tanning device is handed over ready for
operation.
As the studio operator, you are responsible for
observing the electrical regulations applicable at the
installation site.
If the tanning device has not been used for a longer
period of time, it must be inspected by trained and
authorised specialist personnel before being put into
operation again.
BEFORE INITIAL SWITCHING ON
• Attach the supplied warning sign or a sign with the
following wording permanently to the wall near the
tanning device.
Warning
UV radiation can cause eye and skin damage as
well as skin ageing and possibly skin cancer. Ask
the operating personnel for more information.
Wear protective goggles.
Certain medications or cosmetics may increase
sensitivity to UV radiation. If in doubt, consult a
doctor.
• Set the default settings in the service menu.
•
Ensure the correct installation position of the fluo
-
rescent tubes. The tube marking must be visible,
otherwise no tanning effect can be achieved.
• Store these instructions so that they are always at
hand.
Operating modes
STANDBY MODE
The tanning device is in standby mode; this means it
is connected to the mains but is not being used. The
tubes and radiators are switched off. From standby
mode, the device switches to tanning mode and ser-
vice mode.
TANNING MODE
The tubes and radiators are switched on and tanning
is taking place. During tanning mode, the settings for
the current tanning can be changed via the control
panel.
SERVICE MODE
In service mode, the tanning device is configured for
tanning mode, various values can be queried, set-
tings can be made and test functions can be carried
out.
FAN RUN-ON
After tanning, the fan remains in operation for 3 min-
utes to cool down the tanning device. As the tubes
cool down, the fan power is automatically reduced.
Operating instructions
| 1/2
| megaSun K5/K6/K7 PRODUCT SERIES
16
Summary of Contents for MegaSun K7S
