A s s e m b l y I n s t r u c t i o n s
|
KBL Tower pureEnergy 5.0
7
2. Safety notes
2.1 General safety notes
• Follow all instructions given in this manual and all
other documents enclosed with the tanning device.
In addition, observe all relevant statutory provi-
sions and regulations, also those applicable in the
country of operation.
• The tanning device must only be installed and
assembled by qualified, trained and authorized
service technician.
• Arbitrary modifications or conversions of the tan-
ning device are not permissible.
• Observe all danger signs and safety notices
attached to the tanning device.
• Safety notices must not be removed, and safety
equipment must not be disabled or removed.
• The tanning device must only be operated when in
perfect working condition.
• Never operate the tanning device with the outer
covers or acrylic panes removed.
• This tanning device must be operated with an
external timer that is listed in compliance with UL
917.
Before carrying out any work, the tanning device
must be disconnected from the mains voltage.
DANGER
Live parts
Danger of life or fatal injury due to electric
shock when touching live parts.
• Switch neutral
• Secure against reconnection
• Check for neutrality
• Ground and short-circuit
• Cover or shield any adjacent live parts or
components
CAUTION
Hot surfaces
Danger of burns from hot lamps and
housing parts. If the tanning device was
operated before being opened, lamps
and housing parts may be hot.
• Wait until the tanning device has
cooled down.
CAUTION
Danger of pinching
When assembling heavy components,
you can pinch your fingers or hands.
• Wear assembly gloves.
• Be careful when handling heavy com-
ponents.
2.2 Exhaust air connection
Danger of overheating
Under no circumstances the ceiling fan
shall be connected to anything!
• Free and unobstructed airflow
required.
• Do not connect any air duct or vent to
the ceiling fan.
Exhaust air system ->
See also chapter
3.3 Exhaust air modes
in the
Operating Instructions.
Summary of Contents for megaSun pureEnergy 5.0
