M a n u a l e o p e r a t i v o
|
megaSun Shuttle 360°
11
Start-up
•
Fix the supplied sign or one with the following
wording permanently to the wall close to the tanning
unit:
Warning
• UV radiation can cause eye and skin injury. Ask the studio
staff for further information.
•
Wear protective goggles.
• Certain medicines or cosmetics can increase the sensitivity
of the skin to UV radiation.
•
Determine the presettings for the Shuttle 360° in
the service menu.
•
Store these Operating Instructions in a place that
allows for easy access at any time.
Operating modes
The three different operating modes are explained
below.
STANDBY MODE
The unit is in an idle state, i.e. it is connected to the
mains but is currently not used. The tubes and the
tanning lamps are switched off. From the standby
mode, you can change to the tanning mode or the
service mode.
TANNING MODE
The tubes and the tanning lamps are switched on and
a tanning session is in progress. While the unit is in
tanning mode, the settings for the ongoing tanning
session can be changed via the control panel.
FAN RUN-ON
After the tanning session, the fan runs on for 3
minutes in order to cool down the Shuttle 360°. With
the tubes cooling down, the fan power is automatically
decreased.
SERVICE MODE
In the service mode, the presettings for the tanning
mode of the Shuttle 360° are determined. Various
values can be displayed and test functions can be
carried out.
Initialising aquaCool
During start-up and after each emptying of the hose,
an aquaCool initialisation must be performed. In the
course of this initialisation, the hose is
fi
lled with
aquaCool liquid.
The initialisation process is started via the menu item
AAC/AQUA/INIT
in the service menu.
