M a n u a l e o p e r a t i v o
|
megaSun Shuttle 360°
16
Assuming the tanning position
and starting / stopping the
tanning session
WARNING
UV radiation
UV radiation can cause skin and eye
injuries.
• Observe the tanning instructions.
• If in doubt, do not tan.
ASSUMING THE TANNING POSITION
1. Sit down on the seat and lean against the backrest.
2. Press the button on the right-hand armrest in order
to adjust the footrest.
3. Pull the canopy of the Shuttle towards the front
and then downwards in order to close the tanner.
4. Put on the protective goggles.
STARTING
To start the system during the warm-up time, press
the START button. After the set warm-up time has
elapsed, the tanning session will commence
automatically.
STOPPING
Keep the STOP button pressed for at least two
seconds. As an acknowledgement, you will hear a
sound signal, and the tanning-time display starts
fl
ashing. Tanning is discontinued but the time will
continue to be counted. The tanning session can be
continued by pressing the START button if the
available tanning time has not elapsed yet.
After the time given by the timer has elapsed, tanning
is terminated automatically, and the fan will run on for
3 minutes.
Adjusting the volume (optional
feature)
This section is only applicable to units with an audio
option.
0-99%
While the volume is being adjusted,
the value is displayed to the
right of the STOP button.
The initial value is set via AUDIO/VOL.HOT
and VOL.COOL in the service menu.
•
To
decrease
the volume, press the
minus button.
•
To
increase
the volume, press the
plus button.
•
To
turn off
the sound, use the
minus button to set
the value to 0.
AquaCool (optional feature)
On
Off
aquaCool canister is empty
The initial value (
on or off) is set via AAC/
AQUA/AQUA in the service menu. The
cycle time is de
fi
ned via the menu item
AAC/AQUA/Cycle in the service menu.
This section applies only to tanning units equipped
with aquaCool. Here you can switch the aquaCool
spraying on (
plus button, symbol
fl
ashing) or off
(
minus button, symbol not
fl
ashing). aquaCool is
started according to the presettings made in the
service menu. An ongoing spraying process cannot
be stopped.
•
If the system is running short of aquaCool liquid, the
message
Aqua low
is displayed between sessions.
After the
fi
rst message, there is suf
fi
cient aquaCool
left for approx. 2.5 hours of operation with aquaCool
(depending on the preset cycle time; 2.5 operating
hours if cycle time=1min).
•
If the system has run out of aquaCool liquid, the
message
Aqua 0%
appears and the symbol is
crossed out. If you wish to continue to operate the
unit without aquaCool, you can switch off the
messages and the symbol. To do so, go to the
service menu and deactivate the submenu AQ of
PIN II.
