M a n u a l e o p e r a t i v o
|
megaSun Shuttle 360°
26
Carrying out a tube reset
Under the menu item
PIN II/xxxxxh (e.g.
00150h) TUBE
, the current operating hours of the
tubes are indicated. The tube working hours can be
set in steps of 5 hours. After a tube replacement, this
display must be reset to zero.
1. Invoke the
PIN II
menu and enter the PIN.
2. Select
the display of tube working hours
(e.g. 00150h TUBE)
by pressing 5 (
plus
button) or 0 (
minus button).
3. Reset the display to zero by pressing 6 (
minus
button).
4. Save the settings via the START button and leave
the menu by pressing STOP.
Setting date and time
The current time and date are set within the menu
item
TIME/DATE
. This information is required for
the proper execution of the timer function for the
decorative lighting. Date and time are displayed for
approx. 2 seconds after the unit has been turned on.
1. Invoke the
TIME/DATE
menu.
2. Choose the time via START and set the time by
pressing the
plus or minus buttons at the
corresponding number.
3. Choose the date via 5 (
plus button) or 0 (minus
button) and set the date via the
plus or minus
buttons at the corresponding number. The day of
the week is determined automatically.
4. Save the settings via START and press STOP to
exit the menu.
Setting the timer function for
the decorative lighting
The menu item
TIME/DATE
allows you to enter two
times per day at which the decorative lighting is
switched on and off (e.g. Monday at 10:00 h on, at
22:00 h off, Tuesday at 11:00 h on, at 22:00 h off, etc).
If a switching time is not required, it can be deleted by
pressing 1.
1. Invoke the
TIMER
menu.
2. Select the days of the week with START and then
press 5 (
plus button) or 0 (minus button) to set the
desired day.
3. Press START to invoke
AON
and set the desired
time via the
plus and minus buttons 2, 3, 7, 8.
Press START. Proceed in the same way for
AOF
,
BON
and
BOF
.
4. Press STOP to leave the menu.
Presetting of the body fan
The menu item
AIR/A.START
is used to determine
the fan power at the beginning of the tanning session.
Adjustable from 20-99%. During the tanning session,
the studio guest can modify the fan power or switch of
the fan.
1. Invoke the
AIR
menu.
2. Press START and set the desired value by
pressing 4 (
plus button) or 9 (minus button).
3. Save the settings by pressing START and leave
the menu via the STOP button.
