B r u k s a n v i s n i n g
|
Tower Optima
37
Cleaning and replacing the
acrylic panes
The acrylic panes can exhibit small inclusions and
reams. During operation hairline cracks can also
develop. This does not affect or hardly affects the
tanning properties and does not represent a quality
fl aw. The panes are cleaned whenever necessary.
When cleaning the inside, it is recommended to
take the occasion and clean the tubes, too. The
instructions for cleaning and care must be observed.
The outer surface can be cleaned without any
preparatory works.
The panes are dismantled as follows:
Push the pane centrically towards the tubes (e.g.
with your elbow) and pull the upper right-hand cor-
ner of the pane out with the help of the suction cup.
Take hold of the pane from behind and release the
right-hand side in a downward movement. The pane
can then be removed.
To install the pane, insert its entire left-hand
side and press it against the aluminium section.
Bend the pane and push it over the right-hand edge
of the aluminium section. Due to the pane being
bent, it rests in its position.
