B r u k s a n v i s n i n g
|
Tower Optima
38
Cleaning and replacing the
tubes
By regularly cleaning the tubes (see
Cleaning and
care instructions
) you can help preserve their tanning
power. When replacing the tubes, you must also
replace the starters. Replace tubes and starters only
against ones of the same type. The colour fi lter of the
unit lighting must be replaced whenever the tube is
replaced.
Dismantle the acrylic panes as it is described in the
section “Cleaning and replacing the acrylic panes”.
Dismantle the tubes by turning each tube a quarter
turn towards the front or towards the back and then
pulling it out.
To clean the tubes, use warm water and a chamois.
Do not use any aggressive detergents or agents con-
taining alcohol.
When installing new tubes, replace the starters fi rst.
Installing the tubes: Make sure that the inscription
on the tubes is visible, for otherwise, there will be no
tanning effect.
The assembly is carried out in reverse order. Reset
the operating hours counter in the service menu.
Replacing the unit lighting
If the device is lighted by means of high-perform-
ance-LED‘s (Four Seasons), these can only be re-
placed by a qualifi ed specialist if they are defective.
In this case, contact the service department!
If the device is lighted by means of fl uorescent lights,
proceed as follows:
DOOR
• Place a suction cup in the centre of the door panel
and pull the panel towards the front a bit.
