高宝印刷机械科技有限公司
KC Printing Machine (group) limited
28-5
Website: Http://www.dg-padprinter.com
Online contact Skype: yingsuhuakelven
QQ: 726986799
Email:
cjscbsf@126.com 13592766499@VIP.163.com
Use stable power supply in right way and keep earth wire connected.
1.
Voltage regulation: Within AC220V ±10%
2.
Frequency regulation: Within 50Hz ±1Hz.
3.
Please make sure that the power cord of machine is connected to the power supply with earth wire.
3. Air supply
:
(selection: vacuum workbench or vacuum chuck mould)
Correctly use the stable air supply of which the pressure can not vary much.
The pressure of air supply used for the machine is: 6~8Mpa (60~80kgf/cm
2
)
4.
Hydraulic system:
Select stable ISO VG32 antiwear hydraulic oil of “Shell” and the oil pressure of oil pump can not be too
high
The pressure of oil pump correctly used for the machine is: 6~8Mpa (60~80kgf/cm
2
)
5. Working environment:
In order to keep the machine in good condition and facilitate use, the machine shall be in the following
environment and conditions.
1.
Keep air temperature within 18
℃
~ 20
℃
.
2.
Keep humidity within 65%~85%.
3.
Keep altitude ≤1500mm.
6. Correct operation of the machine
In order to keep the machine in good condition and facilitate the use, the operator shall pay attention to
the following points.
1. The oil pump and oil tank for the machine shall adopt ISO VG32 anti
-
wear hydraulic oil of “Shell” and
it is not allowed to add other hydraulic oil to avoid the influence on normal working performance of
hydraulic system.
2. Before the oil pump is started up, please make all switches on operation panel to “OFF” status. The
machine shall be at original position.
3. 4 feet of the machine shall be locked, fixed and located well in operation to prevent the machine from
sliding.
4. Please wear the gloves when the mould is replaced or hot printed to prevent scald.
5. The limbs of people can not enter the machine when it is in operation to prevent personal injured.
6. Please never litter articles on the machine or knock or crash machine parts.
7. Please never cut off the power when the machine is in operation so as to prevent the object from
damage for pressing.
8. Please keep the magnet away from the control box.
9. Please keep combustible or explosive gas or liquid away from the machine.
10. Please never use machine in combustible or explosive place.
