While the system is in service mode the “envelope” icon in the
display will be switched ON. (Figure 8).
Figure 8
LCD Display in Service Mode
4.3 Keys for moving within the Menus.
The keys for moving within the menu are the following (Figure 9):
UP: Button that simulates the Up Key. Up button.
▲
DOWN: Button that simulate the Down Key. Down button.
▼
ESC: Button that simulate the Esc Key. Left button.
◄
ENTER: Button that simulate the Enter Key. Right button.
►
Figure 9
Pushbutton as a Key board for Hoist Condition
Monitoring Unit
4.4 Switching from Tared Load to Actual Load.
The actual load is shown in the display unit as the Tared Load, but an “A” is shown below the
“t” in the bottom right hand side of the display unit. In order to switch from Tared Load to
actual load, this is performed by pressing UP and/or DOWN. Pressing ENTER, the password is
requested.
Figure 10
LCD representing Tared Load
4.5 Resetting the Tared Load.
Pressing the ESC button for several seconds performs the reset of
the Tared Load.
RADS11 and RADF13 Users Manual ver1.2.doc
KCI Hoists Corp. reserves the right to modify this information without prior notification.
Page 16 of 20
