58
DSP-40
5) Put together case again.
6) Confirm HDD information
▶
Put on the system and press SETUP button, select system item.
▶
Using UP/DOWN direction key, select DISK INFO item.
▶
Confirm if new HDD is displayed, and using ratio is 0% or not.
▶
If the using ratio of any HDD is not 0%, it must be formatted. You can refer to page 30 of this
manual.
Pan/Tilt, Zoom, Focus
1. Introduction
1) User can handle the remote camera to move left/right(Pan) and up/down(Tilt). Besides, make
camera zoom in/out and move focus of the camera near/far.
2) This function is valid only the camera with a built-in pan/tilt receiver, Now support 8 protocol,
①
CNB SMART PTZ,
②
SAERIM SSR-100,
③
PELCO D PROTOCOL
④
PELCO P PROTOCOL
⑤
IKEGAWA SM-RX100
⑥
DONGYANG UNITECH
⑦
CRYPTO A120
⑧
SUNGJIN
3) This function is valid only if SYSTEM->SERIAL PORT->DEVICE item value in the setup mode
is PAN/TILT, and PROTOCOL item value is correct with user’s camera. (referring to p28,29) Refer
to camera’s manual for more information.
4) If you want to enlarge screen in Pan/Tilt, Zoom, Focus mode, press ‘zoom’ button. Pressing
‘zoom’ button again, then return to original quad screen.
5) Pressing ‘ESC’ button to exit from Pan/Tilt, Zoom, Focus mode.
