KDF 1500-Plus, Instruction Manual

19 

■

Program one point 

◆

Delete segment 

・

If "----" is set for the temperature setting, the segment for which "----" is set and subsequent segments 

    will be erased when returning to the standby mode with the return key. 
 

◆

Segment insertion and deletion 

・

Pressing the Up key while holding down the Multi key inserts a new segment at the cursor position. 

    If you press the down key while holding down the Multi key, the segment at the cursor position will be 
  deleted. 
 

◆

Erase pattern 

・

If you move the cursor to segment 0 and insert a segment, segment 0 will be in the initial state ("----" 

    is displayed). If you press the return key in that state to return to the standby mode, all the patterns 
  will 

be 

erased. 

    Note

）

Even if the temperature setting of segment 0 is set to "----", it will be deleted in the same way. 

◆

Set item screen page move 

・

By pressing the left/right direction key while holding down the Multi key, you can move to the next page 

  of 

setting 

items. 

◆

Copying segment 

・

Press the START/STOP key to copy the contents of the segment above the cursor position to the 

    segment at the cursor position. 
 

◆

PID group setting 

  The controller of this machine has one set of auto PID and 10 sets of manual PID. Optimal temperature 
  control can be achieved by assigning appropriate constants to each segment.   In the initial state, "A" 
  (auto) is set, and the constant that matches the program temperature is automatically selected. 
  If you want to switch to manual, change the PID setting to 0-9. If set to Manual, the set PID set constants 
 are 

used. 

・

For the setting method, set the value of "0-9" or "A" in the "PID" item of the program mode. 

◆

Soak stop setting 

  The controller of this machine progresses with priority on time. Therefore, even if the set temperature is 
  not reached, it will move to the next segment when the set time for that segment elapses. If the set time 
  of the event elapses, it will move to the next segment. If you program the temperature rise and fall above 
  the furnace performance, it will move to the next segment before reaching the set temperature, so the 
  function to prevent this is the soak stop operation. The soak stop works for the temperature of the set 
  segment. If the temperature does not reach the "set temperature ± soak stop temperature" after the set 
  time of the segment, the START/STOP lamp starts blinking and does not move to the next segment until 
  it enters the range.   If the setting is 0

℃

, the soak stop operation will not be performed. 

・

For the setting method, set the value of "0 to 99" in the "SS" item of the program mode. 

Copy mode 

・

Press the "F2" (copy) key in standby mode to switch to this mode. 

・

The copy source pattern will be the pattern selected in standby mode. 

・

The copy destination pattern can be changed with the UP and DOWN keys. 

・

After selecting the copy destination pattern, press the execute key. You can continue to copy to other 

    patterns with the same operation. 
 

・

When copying is completed, press the return key to switch to standby mode.