KDF HPC-20, Instruction Manual

6 

●

Water Filling for Chiller 

    Remove the white cap of water inlet and install the water funnel provided. 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

(1) Pour every coolant with water funnel. 
(2) Pour water (tap water) until the F line. 
(3) Remove water funnel. 
(4) Put the white cap back on. 

Note) Thin tube connected to the water funnel is for air outlet. Do not remove, cut and close.

They may cause improper pouring.

Note) Do not exceed the F line. It may cause water overflow.

Note) Put the cap of water inlet back on completely to prevent water evaporation.

■

Power On

    After installation is complete, turn the power on. 
    When turning on the power for the first time, wait for 10 minutes until water circulates completely. 
  When 

warning 



  “Chiller Water Current Abnormal” is displayed, turn off and on. 

    In the case of chiller abnormal ERROR due to improper piping of chiller or insufficient amount of water, 
    turn off the unit, check the connection, add water, and turn the unit back on again. 
    When using direct connection of water and error 



  is displayed due to uncirculated or low flow, check 

    the water supply status.