6.2 Bypass Switch Operation
1-
2-
3-
4-
5-
6-
7-
8-
The Bypass is equipped with 4 LEDs that will indicate the operation/status of the switch.
The rocker switch should initially placed in the BYPASS position.
When AC is applied to the switch
, GREEN LED- LINE AVAILABLE will be ON.
The
RED LED–BYPASS
will be on.
In this position the AC Utility will pass through the BYPASS directly to the equipment
If the UPS is OFF or not connected, the AC will go directly to the equipment.
If the UPS system is ON, the AC power will still provide AC to the equipment
In the
BYPASS position
, if there is a power failure, the Equipment will not be backed up or protected.
6.3 AUTO Position ( UPS Operating)
1-
The Bypass is equipped with 4 LEDs that will indicate the Status of the switch.
2-
The rocker switch should be placed in the AUTO position.
3-
The
GREEN UPS ON LINE
LED will be
ON
.
4-
In this position, the AC Utility travels to the UPS, (UPS TURNED ON) then from the UPS through
the BYPASS, directly to the equipment.
5-
IF THE UPS CONNECTIONS ARE REMOVED AT ANY TIME WITH THE UPS OPERATING, THE BYPASS
WILL
TRANSFER UTILITY POWER DIRECTLY TO THE EQUIPMENT
. The Bypass will automatically
transfer into a BYPASS position and the RED LED will be ON
AC IN
Load
Load
1
1
DBL MX-U Series UPS Outdoors 1000-2000W 120V Manual English
20180312
- This manual is for qualified personnel only