51
Figure 49
Configuring the serial port
And confirm by pressing the “Apply” button. A warning message will raise, advising
to store that new configuration is active and saved a permanent way.
This applet can be used just to check which serial communication mode is
active; in this case it is enough to push the “red cross” on the high right side
of the panel.
Please note that MPI mode cannot be selected: when this protocol will be
used by HMI software all required settings will be applied automatically.
5.1.4
Connecting the serial port
A unique DB15 male connector hosts all serial protocols (please check par. 7.3.1 for
pin-out details) so it is necessary to adapt this connection to plant needs; KEB can
supply connector adapters as optional parts but user can adapt DB15 connector by
himself.
5.1.5
Project administration
The C6 HMI / C6 HMI LC has high-performance tools to manage a running project.
With the same mask that is used for the project transfer (see below), you can also:
1.
stop the C6 HMI / C6 HMI LC project from the configuration PC
2.
start the C6 HMI / C6 HMI LC project from the configuration PC
3.
debug the project from the configuration PC
4.
Transfer the project from C6 HMI / C6 HMI LC to the configuration PC
Summary of Contents for C6 HMI LC
