26
Note:
See chapter
2.3 Packaging
.
3.1
Preparation for installation
3.1.1
Select the mounting location
Points to observe when selecting the mounting location:
a)
Position C6 HMI / C6 HMI LC to avoid exposure to direct sunlight.
b)
Position C6 HMI / C6 HMI LC such that it is ergonomically accessible for the
operator.
c)
Choose a suitable mounting height.
d)
Ensure that the ventilation holes are not covered.
3.1.2
Portrait Mounting
C6 HMI / C6 HMI LC can be mounted in portrait mode; the display can be ro-
tated according to the mounting position using the dedicated utility from
the panel control panel.
From the Start menu, select "Settings" and then "Control Panel"; the display
rotation utility is available from "Freescale Display Driver".
Double click on the icon to get the window from where you can select the
desired orientation.
The selection is immediately applied and does not require to be saved in the
registry.
3.2
Checking the package contents
Check the package content for visible signs of transport damage and for
completeness.
In the case of damaged parts, contact your KEB representative. Do not install
parts damaged during shipment.
3.3
Checking the operating conditions
Read carefully the standards, approvals, EMC parameters and technical spec-
ifications for operation of the HMI device. This information is available in the
following sections:
o
Certificates and approvals (see section 7).
o
Electromagnetic compatibility (see section 7).
Check the mechanical and climatic ambient conditions for operation of the
HMI device: Ambient conditions (see section 7).
Follow the instructions for local use of the HMI device: Notes about usage.
Adhere to the permissible rated voltage and the associated tolerance range:
o
24V
o
Range: 18÷36 V
DC
Summary of Contents for COMBICONTROL C6 HMI
