45
Figure 40
Slot for memory card
Attention: potential data loss
Do not remove the memory card
while data is being accessed.
Data on the memory card is lost if
you attempt to remove it while C6
HMI / C6 HMI LC is accessing its da-
ta.
Figure 41
Slot for memory card
Attention: removing the sys-
tem memory card while the project
is running. If you remove memory
card while a project is running, the
project may stop.
Figure 42
Slot for memory card
4.3
Slot for memory card (from 5.7")
C6 HMI / C6 HMI LC can optionally accommodate an SD/SDHC card slot V. 2.0 (push-
push type).
4.4
Installation/removal of a memory card
Insert the memory card into the slot as indicated in the figure. Pay attention to
the beveled edge.
Push the card all the way.
Slot for memory card
memory card (example)
Beveled edge
Summary of Contents for COMBICONTROL C6 HMI
