54
Picture 53
Debugging the project
5.1.8
Debugging the project
You can debug the project in C6 HMI / C6 HMI LC by connecting with the configura-
tion PC.
In order to be able to use the debugging functionality you must prepare your pro-
ject as follows:
1.
Select “Networking” in the project explorer window of COMBIVIS studio
HMI
2.
Enable the property “Debugger” in the Properties window of COMBIVIS
studio HMI
Transfer the project to the C6 HMI / C6 HMI LC and start running.
NOTE
: Ensure that the project is running; otherwise you cannot debug it.
In order to debug the running project of the C6 HMI / C6 HMI LC from the configura-
tion PC, follow these steps:
1.
Select TCP in the upper left list
2.
Insert the IP address of the C6 HMI / C6 HMI LC
Click the button “Attach To Process…”
1
2
Summary of Contents for COMBICONTROL C6 HMI
