9
1.11
Scope of the operating instructions
c)
The operating instructions apply to the C6 HMI / C6 HMI LC family devices in
conjunction with the COMBIVIS studio HMI software. The devices are the
following:
C6 HMI
5.7”
Full aluminum front panel
7.0”W
8.4”
10.1”W
10.4”
12.1”
12.1”W
15.0”
15.6”W
C6 HMI LC
5.7”
Full aluminum front panel
7.0”W
8.4”
10.1”W
10.4”
12.1”
12.1”W
15.0”
15.6”W
1.12
Safety instructions
1.12.1
Installation according to the instructions
Commissioning the device is prohibited until it has been absolutely ensured
that the system in which the device is to be installed complies with all the
applicable EU and international regulation.
1.12.2
Working on the control cabinet
Open equipment
The device is open equipment. This means that the C6 HMI / C6 HMI LC may
only be integrated in housings or cabinets, where it can be operated from
the front panel. The cabinet in which C6 HMI / C6 HMI LC is installed may on-
ly be accessed with a key or tool and only by trained and authorized person-
nel.
Dangerous voltage
Opening the cabinet may expose high voltage parts. Before opening the cab-
inet always disconnect the power.
1.13
Notes about usage
C6 HMI / C6 HMI LC is approved for indoor use only.
C6 HMI / C6 HMI LC may be damaged if operated outdoors.
1.14
Applicable standard
Please refer to section 8 for details about the relevant standards.
Summary of Contents for COMBICONTROL C6 HMI
