23
PrODUcT DeScrIPTION
2.3 Product features
This instruction manual describes the power circuits of the following devices:
Device type:
Drive converter
Series:
COMBIVERT F6
Power range:
2.2...7.5 kW / 230 V
4...15 kW / 400 V
Housing:
2
The COMBIVERT F6 is characterized by the following features:
• Operation of three-phase asynchronous motors and three-phase synchronous
motors, in operating modes open-loop or closed-loop with and without speed
feedback
•
Following fieldbus systems are supported:
EtherCAT, VARAN, PROFINET, POWERLINK or CAN
• System-overlapping operating concept
• Wide operating temperature range
• Low switching losses by IGBT power device
• Low noise development due to high switching frequencies
• Different heat sink concepts:
• Air cooler as built-in version
• Air cooler as push-through version with IP20 degree of protection
• Air cooler as push-through version with IP54 degree of protection
• Temperature-controlled fan, easily replaceable
• Depending on the operating mode, the torque limits and the s-curves are adjusta-
ble (to protect the gearbox).
• General protection functions of the COMBIVERT series against overcurrent, over-
voltage, ground fault and overtemperature
• Analog inputs and outputs, digital inputs and outputs, relay output (potential-free),
brake control and -supply, motor protection by I²t, KTY- or PTC input, two encod-
er interfaces, diagnostic interface, fieldbus interface (depending on the control
board)
Summary of Contents for COMBIVERT 10F6 Series
Page 2: ......
Page 82: ...82 NOTES...
