KeContact R10 CM
17
Installation Manual V 1.01
(translated)
8.2
Cleaning the cable reel
•
Caution. Never clean the reel with solvents, scouring agent or scrubbing sponges.
Use a soft cloth and a bit of water or a mild cleaning agent.
•
Avoid that foreign bodies or liquids get inside the cable reel. Check the protection
covers, totality of the screws of the enclosure as well as damages at the enclosure
and the cable exit periodically and in particular after strong shocks (e.g. Fall).
To clean the inside of the KeContact R10 a vacuum cleaner or compressed air can be
used.
CAUTION!
When cleaning the inside with compressed air safety glasses must be worn!
8.3
Repair / Replacing the brake
The KeContact R10 has a brake (Part number:
RC 3-0090-00-227
).
The brake limits the rolling speed when retracting the cable. The brake loses power
gradually over time and should be replaced.
Use this procedure to replace the brake on the KeContact R10, tool required phil
-
lips-head screwdriver, screw included in the spare part. Max Torque 0,05Nm.
•
Disconnect and disassemble the device from the wall mount.
(not necessary but recommended)
•
Place it on a flat surface with the back facing upwards.
(not necessary but recommended)
•
Unscrew the 3 screws and remove the brake.
•
Insert the new brake and screw the three new screws provided.
•
Reposition the device on its wall support.
Maintenance
