21
Mechanical installation
Operation Manual ServoOne CM-L and ServoOne CM-A
ID no.: 1800.208B.1-00 Date: 03/2020
Mechanical installation
3.6 Cooling circuit connection
Note:
The "liquid cooling" device model is in preparation.
Connect the flow from the liquid cooling to the connection marked.
The cooling circuit must be bled prior to commissioning. You will find further
notes on the liquid cooling in the appendix A.5.
The device has a capacity of approx. 0.5 l of coolant. After the disconnection of the
connections, liquid may be left in the device and escape if the device is tipped.
We recommend the usage of a self-sealing liquid coupling (not included in the scope
of supply) to prevent the coolant escaping and to make it possible to disconnect and
connect in the filled state.
1
2
return
flow
3
4
5
2
flow return
1) Liquid connection with 3/8 inch female thread
2) 90°elbow fitting with 3/8 inch female thread and male thread
3) Self-sealing liquid coupling
4) Self-sealing quick-release connection with hose connection
5) PUR (polyurethane) hose with clip
Note:
Items 2 to 5 are not included in the scope of supply. You will find these in the cooling circuit connection set
(LCS01). Please order separately.
Figure 3.7 Cooling circuit connection
Dimensional sketches, wall mounting liquid cooling ServoOne CM-A
390
430
164
27
110
4,80
6
378
110
25
G 3/8 - 15 tief
247,50
70
47
251,04
75,20
D1
D
G
F
A1
H
H2
C
B
A1
A
E
T
T2
T
T1
H1
H3
A2
S
Figure 3.6
Dimensional drawing ServoOne CM-A (BG3) liquid cooling, for dimensions see
Table 3.1
