11.6.25.25 Error 24-51 (emergency code 7300h)
Cause: Channel 3 Initialization, HDSL: common error
Suggested steps:
Initialization encoder
channel 3
l
Error during the initialization routines of
encoder channel 3.
l
In any case look at init outputs in the message
window of the DriveManager.
l
The most common cause of error is the wiring
to the encoder.
11.6.25.26 Error 24-52 (emergency code 7300h)
Cause: Channel 3 Initialization, HDSL: error reading the initial position
Suggested steps:
Initialization encoder
channel 3
l
Error during the initialization routines of
encoder channel 3.
l
In any case look at init outputs in the message
window of the DriveManager.
l
The most common cause of error is the wiring
to the encoder.
Initialization HIPERFACE-
DSL
l
Error during the initialization of HIPERFACE-
DSL (HDSL).
l
Probably there is a problem due to insufficient
mounting of the encoder. Make sure that the
encoder has been mounted correctly.
l
The problem could also have been caused by
mechanical vibration during initialization.
ID No.: 0842.26B.5-01 Date: 09.2020
ServoOne - Device Help
410
11 Alarms & warnings
11.6.26 Error 25: Encoder cyclic process, common error
11.6.26.1 Error 25-1 (emergency code FF00h)
Cause: Encoder cyclic, Getting commutation: position difference too high
Suggested steps:
Check the Parameter of autocommutation!
Encoder channel, cyclic
evaluation
l
Error during the cyclic evaluation of an
encoder channel.
l
In any case look at init outputs in the message
window of the DriveManager.
l
The most common cause of error is the wiring
to the encoder.
11.6.26.2 Error 25-2 (emergency code FF00h)
Cause: Encoder cyclic, Getting commutation: offset difference outside tolerance (>
30 grad)
Suggested steps:
Check the Parameter of autocommutation!
Encoder channel, cyclic
evaluation
l
Error during the cyclic evaluation of an
encoder channel.
l
In any case look at init outputs in the message
window of the DriveManager.
l
The most common cause of error is the wiring
to the encoder.
