3. Press the push pin button on the base to locate the tool.
4. Turn on the laser (do not stare into the laser beam)
5. Adjust the laser line to desired position.
6. When need to project the horizontal line on the wall, turn the tool until the bubble in the
horizontal level is between the two lines. (see Fig.8)
7. When need to project the vertical line on the wall, turn the tool until the bubble in the
vertical level is between the two lines. (see Fig.9)
8. When need a line with any angle to the above laser line, keep the tool static, rotate the
alignment plate until the “0” scale align to the pointer. (see Fig.8)
9. Turn the tool according to the desired angle and make the pointer indicate the
corresponding scale on the alignment plate.
●
Tips:
●
The tool is designed to project a baseline on the surface of the object. The reflection of the
baseline on any other surfaces cannot be used as a reference.
●
For convenient operation, the project direction of the laser line is generally from bottom to
top and /or from right to left when operate the laser tool.
●
If the laser line is darken or not visible during operation, please check and replace the
battery.
●
The tool is recommended for indoor use. The visibility of the laser will be affected if the
tool is used outdoor.
Cautions
●
Operate with care and do not let the tool drop down.
●
Do not disassemble the tool in case of damage.
●
Clean the tool gently with soft fabric.
●
Please place the tool with workbox when not in use.
●
Do not use where there is dust and water drop, in order to avoid
pollution laser lens.
●
Remove the battery when not in use for an extended period of time
in case of damage of tool by deterioration of battery.
4
