5
b)
The probe is flexible, which helps you to get to hard-to-reach areas. Please don’t insert or bend the
camera probe by force. Please do not over bend the probe (normally, the bending radius should more
than 5cm), so as not to cause permanent damage to the probe.
c)
Don’t use the probe or camera head to remove barricades, clear pathways or clogged areas. It must not
be used as a fishing rod or tape.
d)
The hand-held LCD display is not waterproof. The camera head and its cover are waterproof, but not
acid-proof or fireproof. Touch with these materials will damage the camera head’s protective plastic.
Do not immerge the camera head into corrosive, oily places or contact high-temperature objects.
e)
Don’t place the inspection into anything or anywhere that may contain a live electrical charge. Please
check following methods to avoid injury.
For walls:
For inspecting inside the walls, make sure to circuit of the whole house is shut down before using
the tool.
For pipes:
If you suspect a metal pipe could contain an electrical charge, have a qualified electrician to
check the pipe before using. Ground circuit, in some cases, can be returned to the cast aluminum pipes
and cause them to be charged.
For automobiles
：
Be sure the automobile is not running during inspection. Metal and liquid under the hood
may be hot. Don’t get oil or gas on the camera head.
Operation Instructions
Please don’t operate this product unless the manual has been read and proper training has been
completed.
Don’t turn on and off the device continuously. Please allow more than 2 seconds between each On
and Off for the unit to properly boot up or shut down. If there is unusual image, please turn off the
unit and try again.
“
”will appear, when the battery is low.
Don’t immerse the handheld display unit into water, which will result in electric shock and damage.
Only while the product is assembled well, the camera head is water-proof, but the handheld display
isn’t water-proof.
Don’t use the product if condensation forms inside the camera head.
If the tool couldn’t work well after turning it on. Please take the battery out. It is dangerous, wait
until it could repaired
Store idle product out of reach of children and other untrained persons. The tool is dangerous in the
hands of untrained users.
Maintain the inspection tool with care. If the tool is dropped, check for the breakage ,which may
affect the tool’s operation. If it is damaged, have the tools serviced before using. Many accidents are
