19
Picture 4-7 Motion Detection
4.2.1
Set Area
Motion detection supports full area detection and maximum 4 user-defined areas.
1) Go to
Settings > Event > Intelligent Function > Motion Detection
, and
check
“
Enable
”.
2) Click
“
Clear All
” and then “
Edit
” and the image will be divided into 16 columns
and 12 lines of small squares. Click a square, drag toward lower right and click
“Stop”. Then the area is the detected area and it turns purple red. A camera
can support max 4 motion detection areas at the same time. Draw an area