8. Install the first element, no. 5. Centre it on ele
-
ment, no. 4.
Install the S-bend using jointing compound.
9. Install a further element no. 5 in mortar.
Install pipe 330 mm.
10. Install a further three elements no 5 and one ele
-
ment no 6 in mortar.
Install pipe 390 mm.
K20 Rear connection
11.
For rear connection.
Cut the 500 mm pipe to a
suitable length. Hang the pipe in the hole prepared
in the chimney breast. After this, fit the 90-degree
pipe on to the 390 mm pipe. Finish by sliding the
pipe in the wall with the 90-degree pipe.
NOTE! Rear connection through a flammable
wall.
If the flue is to be run through a flammable wall, the
connection pipe must be enclosed by a fire-resist
-
ant, lined shaft (Masterboard, Minerit or similar) and
fireproof insulation that is at least 100 mm thick.
Thus, there must not be any flammable material
closer than 100 mm from the flue.
If the outer diameter of the flue is ∅153 mm, the
shaft must be at least 353 mm x 353 mm.
For top connection of the stove, jump forwards to
point 13.
- 8 -