- 7 -
INSTALLATION INSTRUCTIONS
Before starting on the installation of the stove, the following steps need to be fully completed:
The chimney:
Alternative 1 An existing chimney prepared for rear connection
Alternative 2 A newly installed chimney prepared for rear connection
Alternative 3 Preparation for a new top connection chimney
Outdoor air supply
(if so required)
Hearth floor plate
(unless a floor plate or floor glass is to be installed afterwards)
1. Move the stove indoors and put it into
position. Adjust the stove horizontally and
vertically using the feet under the base by the
floor.
A suitable place to check horizontally and
vertically with the help of a spirit level is on
the hearth's sealing plate.
Tip!
The stove is vertical and horizontal
when the door stays open at an opening an
-
gle greater than 90-95 degrees and when it
closes automatically at an opening angle less
than 85-90 degrees.
Where applicable, connect outdoor air to the
hearth.
2. To dismantle the front/door, start by
unscrewing the two front bolts that secure
the inner roof to the cassette front. After this,
loosen the centre screw at the centre of the
inner roof's front edge.
Then open the door fully. Unscrew the four
bolts in each corner.
After this, carefully pull the front towards you
until it comes free from the two guide rails.
Carefully put the front to one side, to avoid
damage to the opening handle. The front and
door weigh approx. 35 kg.
