11
A.
Align the fixing plate on internal face of the opening, so
that the rails of the Safety Gate match up with the top of the
Guardrail System. Select the correct U Bolt & pass it through the
Steel Safety Clamp, around the support leg/structure and feed
through the top holes of the fixing plate.
TOOLS REQUIRED
You will need the following in order to install the
Kee Gate:
• Marker Pen
• Tape Measure
• 1No 3/8” Ring Spanner
• 1No 5/32” Ring Spanner
• 1No 15/16” Ring Spanner
• 1No 3/16” Hex Key
• 1No ½” socket
• 1No 11/16” socket
• 1No 15/16” socket
• Torque Wrench 10- 60 Nm approx
• Small Magnetic Spirit Level
Assembly and Mounting of Gate to Floor
Establish that the gate will close in direction of hazard!!
Failure to do so could result in Death or serious injury.
D.
Torque all nuts/U Bolts to 39Nm using the 11/16” or ½”
socket and torque wrench.
C.
Select the correct U Bolt & pass it through the Steel Safety
Clamp, around the support leg/structure and feed through
the middle holes of the fixing plate. Using a ½” or 11/16” flat
washer and nut connect the U bolt to the Support Leg/Structure
and tighten. Repeat step for lower holes in faceplate.
B.
Using a 11/16” or ½” flat washer and nut connect the U bolt
to the Support Leg/Structure and tighten.
E.
To cut the gate to the correct size simply place a straight
edge/magnetic level as shown and measure the distance
between the outside edges of the vertical tube on both gates.
(DO NOT CUT AT THIS MARK!)
Mounting double gates and tensioning spring
