b)
Peel back rubber end cap and slide 2no. M8 bolts onto the
end of the aluminium extrusion. Replace rubber end cap. Pass
M8 bolts through 62-6 fitting and secure using M8 fixings and
a 13mm spanner. Using a torque wrench tighten to 15N/m.
Repeat process for 3 other legs.
b)
Peel back rubber end cap and slide 2no. M8 bolts onto the
end of the aluminium extrusion. Pass M8 bolts through 199-6
fitting and secure using M8 fixings and a 13mm spanner. Using
a torque wrench tighten to 15N/m. Repeat process for 3 other
legs.
a)
Unpack and check contents. The package should contain
1no. platform, 2no. weighted bases and M8 fixings. Place
weighted bases in position either side of obstacle. Lower
platform into position ensuring 199-6 fitting lines up with the
aluminium extrusion as per diagram.
c)
Ensure all fixings are tight with fittings torqued to 29N/m and
M8 nuts tightened to 15N/m.
c)
Ensure all fixings are tight with fittings torqued to 29N/m and
M8 nuts tightened to 15N/m.
Assembling and fixing the Mini Step Over - Free standingg
a)
Unpack and check contents. The package should contain
1no. platform, 4no. legs, 2no. weighted bases and M8 fixings.
Position weights either side of obstacle. Position legs so that the
62-6 oblong fittings are at the top and 61-6 sit on the floor. Slide
fitting to tubes with vertical legs on the inside of the horizontal
tubes as per diagram above. Tighten the grub screws.
STMFS400* MODULES
STMFS200* MODULES
16
