KeyGrabber Nano
Copyright © 2013 KeeLog
7
Viewing recorded data
Once keystroke data has been recorded, it may be retrieved on any computer with a USB
port. This is done by switching to Flash Drive mode. The
KeyGrabber Nano
and keyboard
should be connected in the same way, as during normal recording.
Each device has a built-in 3-key combination (by default K, B, S). Press these 3 magic keys
simultaneously
to trigger Flash Drive mode.
After a few seconds, the hardware keylogger will automatically get detected as a mass
storage device. The operating system will use the standard built-in mass storage driver (
MS
Windows 7
in the following examples).
Depending on the drive letters available, the device will be visible as a new drive, for example
F:. Use the systems file manager to browse this disk (for example
Explorer
). The keyboard
will be disconnected and unavailable, so the mouse must be used to browse the disk.