3.3
Assembly
3.3
Stage 4
1.
Place the base extrusion on the edge of the
bench so the lip hangs over the front edge of the
legs. Slide the square nuts into the recess as
shown and place one near to each leg. Slide the
workshop fixing plates into their groove and
position them at approximately equal spaces along
the base extrusion.
2. Using the 5mm hexagon wrench fix the base
extrusion in place on the bench with the base
clamps and cap screws.
3.
Fix the lift & hold mechanisms to each end of the
base extrusion with three self taping large
screws on each end, do not at this stage tighten
the screws fully.
View from underneath
SQUARE
NUT
WORKTOP
FIXING PLATE
