Excalibur 3S installation manual
The world’s finest cutting machines
www.keencut.com
+44 (0) 1536 263158
+1 (716) 748 6203
sales@keencut.co.uk (UK HQ)
sales@keencut.com (US sales)
Scan the QR code or
click here to view this document online >
Page 13 of 35
2. Installation
2.1 Adjusting the legs
The first stages of assembly are carried out with the machine laying on the floor. NOTE: When lifting the main body from
the box do not lift using the black handles on the cutters. DO NOT untie balance weight cord at this stage.
Slacken the bottom two screws on each leg using the 5mm
Allen (hex) key and extend the
telescopic parts to the desired length. (These can be re-adjusted
later before fixing the
machine to the wall). Tighten screws firmly to clamp in position.
Swing both legs outwards as far as they will go.
