Worktop Material Guide Installation
Manual
The world’s finest cutting machines
www.keencut.com
+44 (0) 1536 263158
+1 (716) 748 6203
sales@keencut.co.uk (UK HQ)
sales@keencut.com (US sales)
Scan the QR code or
click here to view this document online >
Page 7 of 17
2.2 Position
IMPORTANT: Be careful to place the Material Guide so it will not be in the way of any moving equipment or provide finger
traps.
Lay the Material Guide in the desired position using measured
pencil lines or paper tape to assist. If it is to be aligned with
another guide/object use a straight edge or the edge of a large
piece of board to help.
IMPORTANT: Ensure that enough space is left for when the end
caps are installed at a later stage
Once you are happy with the location, use a posi head
screwdriver to fix the Material Guide in position using 4 of the
wood screws.
IMPORTANT: DO NOT fix the plastic end caps at this stage, this
is to be completed after the Material Guide has been calibrated.
