Worktop Material Guide Installation
Manual
The world’s finest cutting machines
www.keencut.com
+44 (0) 1536 263158
+1 (716) 748 6203
sales@keencut.co.uk (UK HQ)
sales@keencut.com (US sales)
Scan the QR code or
click here to view this document online >
Page 9 of 17
2.4 Fix and calibrate the measuring scale
The self-adhesive measuring scale fixes to a stainless-steel strip
which can be slid to make small calibrations once it is stuck in
place. Ensure the strip is centralised before proceeding.
Two measuring scales are supplied one reading left to right the
other right to left.
Take a piece of rigid card or similar board around 50cms (18”)
long and place it against the Material Guide such that one end
overlaps the ‘zero’ position.
Slide the measuring stop onto the Material Guide and fasten it
in position against the edge of the board.
Either mark or cut the board at the zero position. Note the
measurement of the board from the zero position to the edge
against the measuring stop. Make a pencil mark on the
aluminium extrusion as shown. Remove the measuring stop.
