6.2
2
Operation
6.2
2
How to use the Pull Bar System
Cutting boards above 165cm high is done so in two stages, the first using the Pull Bar
then disengaging the Pull Bar and using the handle directly connected to the Cutting Head.
To cut larger than about 165cm (65”):
1. Raise the Cutting Head to chest height, select the cutting tool required and engage it
in position ready for cutting.
2. Check the black plastic handle on the Pull Bar is pointing out towards you.
3. Push the Cutting Head up far enough so the stub shaft on the Pull bar can be twisted
to engage in the slot of the handle bracket (see above).
4. Using the Pull Bar push the Cutting Head to the top of the machine.
5. Insert the material to be cut into the machine and clamp in position.
6. Pull down on the Pull bar to cut, the stub shaft is designed so that it locks itself in
position when the Cutting head is moved up or down preventing the Pull bar from
being able to twist out of place.
7. When the board has been cut as far as the Pull bar will allow, slightly push the Pull Bar
up and twist it away from the Cutting Head to disengage it. Raise the Pull bar all the
way up to its rest position
6. Continue the cut using the Cutting Head handle in the normal way.
3
