11
Among these settings, the number of cycles for spraying disinfection: only available under on-the-
way mode. It refers to the number of cycles for spraying disinfection by the robot on the given route.
Users can set 1-5 times, or unlimited times for the number of cycles;
s
Intensity level of spraying: refers to the speed of spraying of robot when spraying operation is
started under the on-the-way mode and dual mode. The speed of spraying is divided into 5 levels.
Level 1 is the slowest while Level 5 is the fastest. With the speed increase, the amount of spraying
increase, the disinfection efficiency will be higher.
Duration of stay: refers to the irradiation time (15min – 90min) under the fixed-point mode and dual
mode with the ultraviolet equipment turned on. The longer the irradiation time, the better the
disinfection effect will achieved.
Motor unlock switch during pause: if this function is turned off, the user clicks on the screen, and
the motor will not unlock when the robot pauses, then the user cannot push the robot to move.
Charging
1. Robot Autonomous Intelligent Recharge
The robot has the function of intelligent autonomous recharge. The robot will return to the charging
port to recharge if both two conditions bellow are met. Please ensure that the charging port is
secured in position and energized.
The electric quantity of the robot is lower than the recharge value set by the user.
The robot is idle and its electric quantity does not reach 100%.
2.
Adapter charging
(robot operation is prohibited during adapter charging)
The robot can be charged through the adapter as follows:
1
Power off the machine.
2
Open the silicone sleeve outside the [Charging port] on the back of the robot and connect the
robot with the charging plug of the adapter.
3
After successful connection, the adapter indicator will turn red (if the indicator light is yellow,
please press the indicator light, then the light it will turn red).
4
The charging is complete when the adapter indicator light turns yellow. Then, please disconnect
the adapter and plug the silicone sleeve outside the charging socket of the robot.
