The Cable
Be sure the cable is in good condition and is attached properly. Do not use the winch if
the cable is frayed. Do not replace the cable with a cable of lesser strength.
The Battery
Be sure the battery is in good condition. Avoid contact with battery acid or other con-
taminants. Always wear ANSI approved eye protection when working around a battery.
Have the engine running when using the winch to avoid running the battery down.
Stand Back
Stay out of the direct line that the cable is pulling. In case it slips or breaks, it will
“whiplash” along this line. Keep hands, clothing, hair and jewelry clear of the winch
while in use. Use a spotter to assist you in assuring that it is safe to operate the
winch. Make sure this person is out of the way of the vehicle and the cable before
activating the winch.
Power Limits
Do not attempt to exceed the pulling limits of this winch. Never use the hand crank to
“assist” the winch. This will damage the winch and may cause personal injury.
Permanent Mounting
1. Select a mounting site on the bumper of your vehicle, truck bed, boat trailer, or other suitable location.
NOTE: This winch can generate 2,000 lbs. pulling force. Be sure the location you select can withstand this
much force.
2. Align the winch with the desired location and mark for drilling the locations of the 3 holes on the base
of the winch.
3. Drill these holes where you wish to mount the winch on a stable structural support location on your vehicle
or trailer
(Figure 7)
.
4. Using hardened steel bolts at least 3/8” in diameter, install your winch to the location.
SPECIAL WARNINGS WHEN USING THIS ELECTRIC WINCH
Using this powerful tool may create special hazards. Take
particular care to safeguard yourself and those around you.
INSTALLATION - Mounting Your Winch
Your winch is designed to be mounted temporarily using the RAPID MOUNT Ball
Trailer Hitch Mounting Plate. However, you may also mount your winch permanently
6
!
!
WARNING
FIGURE 7
Summary of Contents for KWSL2000RM
Page 31: ...Notes Notas...