BrewZilla 35L - Gen 4 Instruction Manual
Page
15
of
31
Last Updated 22/03/2022 16:53 PM
Press the
Return
button until the Heat percentage is highlighted then use the up or down
arrows to change the heating power.
Operation of the BrewZilla through the RAPT Portal
The brewery can be controlled via a profile generated in the RAPT Portal. Once you have
registered your device on the RAPT Portal select
Profiles
and
Create New Profile
. Then add
your profile steps such as strike, mash, mash-out, sparge, boil etc. Once you have made your
profile then either select
Send Profile to Device
from the profile menu or
Start Profile
Session
on the Dashboard to send the profile to your BrewZilla controller. Once the profile
has been sent to the device it will automatically energise the device and begin the profile.
You will still need to turn the pump on/off on the controller and adjust the power and pump
output percentage (if required) manually on the controller.
Mashing
Once you have assembled your boiler, digital controller and malt pipe you are then ready to
add grains to begin mashing.
Ensure that you have added the correct volume of strike water and this water is heated up
to the correct strike temperature according to your recipe. Then add your malt pipe with the
bottom perforated screen installed into your boiler, such that the top lip of the malt pipe
rests on the wire supports which are nested in the groove at the top of the boiler.
You can then pour your grain into the malt pipe. The malt pipe is designed to take up to
11.5kg grain but in the majority of recipes you will probably only used 4-5kg.
It is best to stir the grain periodically while pouring it into your malt pipe to break up any
dough balls (dry spots). Once you have added all the grain thoroughly stir the grain to
ensure all the dough balls have been broken up. This will take about 2-5 minutes.
Then insert the top screen into the malt pipe so that it lightly rests on top of the grain. After
all the grain has been stirred in and the top screen inserted, you can then assemble the
recirculation pipe to recirculate during the mash.
