BrewZilla 35L - Gen 4 Instruction Manual
Page
7
of
31
Last Updated 22/03/2022 16:53 PM
Assembling the Digital Controller
The BrewZilla Digital Controller is mounted in a higher position with a tilting frame so you
can adjust the angle of the screen depending on how tall you are improving the overall
ergonomics of the system.
To mount the Digital Controller onto the boiler, slide the controller
onto the bracket using the grooves which are moulded into the
rear of the controllers housing.
Adjusting the Angle of the Digital Controller
To adjust the angle of the screen, loosen the two bolts which hold the bracket in place on
the boiler. Then adjust the angle of the bracket to your desired angle and tighten the bolts
to hold the bracket in this position.
Tip: if you require a greater angle for the Digital Controller the mounting bracket can be
rested on the bolt as shown below to the right.
